RV Tools, Test Gear & Repair Parts

Real state of charge on your phone instead of guessing from voltage. It goes on every install we do.

Turns your phone into heat vision. We use thermal to find a cooking lug or a failing breaker before it melts something.

Reads AC amps without breaking the circuit. The meter we grab first when a pedestal or an A/C acts up.

Finds chafed or water-soaked wiring that a regular meter says is fine.

Multimeter, non-contact voltage tester, and outlet tester in one box. The starter kit we would hand any new RV owner.

Snakes behind walls, into tanks, and under slides so you see the problem before you cut anything.

Solid battery-cable crimps without a die set. A loose lug gets hot; a good crimp does not.

Greases trailer bearings, zerks, and slide gears. The whip hose reaches the tight fittings.

Logs pedestal voltage on your phone and cuts power before a bad post fries the coach.

Two stick-on sensors for your 20/30/40 lb cylinders plus an LED display. No more shaking the bottle.

Tells you exactly how many inches to raise each side. Leveling without the yelling.

Quiet backup power for a CPAP, fridge, or laptop when the generator cannot run.

No Amazon listing we trust right now. Send us the model number for a quote.

No Amazon listing we trust. Send us the model number for a quote.

Model-specific. Send us the model number and we will quote the right part.

No Amazon listing we trust. Send us the model number for a quote.

Model-specific. Send us the model number and we will quote the right part.

Model-specific. Send us the model number and we will quote the right part.

Model-specific. Send us the model number and we will quote the right part.

Currently unavailable on Amazon. Send us your converter model for a quote.

Match the amp rating to the coach.

We use this first on every 12V call: fast power and ground checks at lights, pumps, and slide motors.

We use this for every voltage, continuity, and resistance check, 12V or 120V.

We use this to trace roof and wall leaks and map water damage before we open anything up.

We use this to spot hot lugs, failing breakers, and cold spots from a leak behind a wall.

Needed to program a MultiPlus with VEConfigure.

Ratcheting crimper for terminals.

Battery-cable lug crimper.

Ferrule crimper for Victron and terminal blocks.

Pro wire stripper.

Pro DC clamp option.

Fast stripping, 8-22 AWG.

Heat-shrink on every terminal.

Everyday driver for panels and terminals.

Protects the coach from a bad pedestal.

EMS with app logging.

Find hot lugs and loose connections.

Label every circuit.

Connector corrosion prevention.

Furnace, water heater, and fridge LP pressure check.

Protects plumbing at parks.

Torque battery and busbar lugs to spec.

150 PSI, enough to air up a low tire roadside.

Check pressure cold.

Pressure and temperature per tire.

Keep a box with the sewer hose.

Budget DC clamp for parasitic-draw and charge-current checks.

Budget alternative to the Ancor lug crimper.

Spins off jack, hitch, and bay-door bolts in tight spots. Battery and charger included.

Small enough for a pass-through bay. Drives screws, runs stabilizer jacks, drills pilot holes.

More power for bigger fixes. Two batteries, charger, and case.

Two batteries and a charger. Runs slide screws, panels, and stabilizer jacks with a socket adapter.

Square, Phillips, and Torx bits for the screws RV builders use, plus nut drivers.

Compact case that fits a pass-through bay. Covers most owner fixes.

Hammer, pliers, level, and sockets in a small case for the rig.

Multimeter, non-contact voltage tester, and outlet tester. Check a pedestal before you plug in.

SAE and metric sockets and wrenches for jacks, hitches, and battery terminals.

Deep sockets for lug nuts and leveling jack bolts.